Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
wheels and tires
#1
i have a 2010 nissan frontier SE. and i want to put 24s on but not sure if theyll fit with the stock suspension. can some one help me
Reply
#2
Welcome to The Spot.
I guess if you can find a 24 with a 6 on 4.5 bolt pattern, it will fit with a 285/35-24 tire. They are ~32" diameter. Stock width is 265, but a 285 will fit if the wheel isn't offset out too far. Stock offset is +30mm. The lower the number, the further out they will be. You will also have to check brake caliper clearance of each specific rim.
Also, a low profile tire looks better with a little drop, but I cannot help with that. Maybe just lower the rear to be level with the front.
Be sure and post pics if you get them.
06 nismo CC 4X4: SOLD and replaced with 2017 Jeep Unlimited Rubicon; Teraflex 3" lift, 315/70-17 Cooper STT PRO tires on Fuel Trophy wheels, JCR bumpers front and rear w/Warn 9.5cti winch in front, Ace sliders, GraBars, Weathertech window deflectors and floor liners
98 Jeep Wrangler in the garage, 2" lift, 33X12.50 BFG MTs on 15X8 MT Classic Locks, Pioneer/MTX/RF P3 Sound, Borla Header w/Flowmaster
63 and 67 Nissan Patrols (under construction)
Reply
#3
ehh right on maan thanks alot
Reply
#4
24's are thight on the wheel wells up front. I went with 20's for a little bit more meat on the tires and they just barely make it into the front. The back is not an issue.
[Image: 3gears.gif]06 CC 4X2 6sp Avalanche White NISMO SPORT[Image: drive.gif]
[Image: 43d20b1b.jpg]
Click on the picture for my Frontier thread
Reply
#5
(07-16-2012, 11:18 PM)Shift_Avenger Wrote:  24's are thight on the wheel wells up front. I went with 20's for a little bit more meat on the tires and they just barely make it into the front. The back is not an issue.

As long as the overall tire diameter is the same, the width isn't more than a 285, and the offset is not severe, it should fit. May have to remove the mud guards.
06 nismo CC 4X4: SOLD and replaced with 2017 Jeep Unlimited Rubicon; Teraflex 3" lift, 315/70-17 Cooper STT PRO tires on Fuel Trophy wheels, JCR bumpers front and rear w/Warn 9.5cti winch in front, Ace sliders, GraBars, Weathertech window deflectors and floor liners
98 Jeep Wrangler in the garage, 2" lift, 33X12.50 BFG MTs on 15X8 MT Classic Locks, Pioneer/MTX/RF P3 Sound, Borla Header w/Flowmaster
63 and 67 Nissan Patrols (under construction)
Reply
#6
(07-11-2012, 08:47 PM)808 frontier Wrote:  i have a 2010 nissan frontier SE. and i want to put 24s on but not sure if theyll fit with the stock suspension. can some one help me

Not sure if they changed my suspension 2008 frontier nismo 4x2 but it looks stock and it came with 24's on it, hope that helps.Joe
Reply
#7
I recently purchased a used 2008 Nissan Frontier Nismo 4x2 Crew Cab in great condition/shape BUT it has these HUGE 24 inch HELO clown rims with Carbon Series 215/30ZR24 CS86 tires on it right now, don't get me wrong I love the look of the tread pattern and if the rims were not so huge they would look awesome as they are the polished with black inserts on a black truck and I am not a spoke rim guy usually. Anyway I am interested in possibly gong back to the stock diameter of 16" but I am not opposed to POSSIBLY looking at going up to an 18", I just don't see going any bigger as that is just not my style (yes I am old school laugh all you want).

AnyWHO, I have found the closest thing to what/would like to put on it is a set of the Mickey Thompson Classic III Wheels with Polished Finish (16x10"/6x5.5"). I believe my my oem bolt pattern is 4.5 though, and I understand I will need an adapter kit to go to the 5.5 bolt pattern. I have a few questions if someone can help me please I have never used any type of adapters myself and years ago was warned against it but as I cannot find a similar rim or one the is polished and looks like the old school 5 hole bullet hole rims that I want. If anyone knows of any (good rims please not any that will rust or tarnish if taken care of correctly), polished rims that will fit safely and are similar (especially that are along the same lines of the classic 5 hole bullets and definitely are NOT the small punch hole style) or if anyone has any negative experiences with a 16x10 on this truck please let me know.

1st, Is it safe to use an adapter on this/any vehicle?
2nd, If so, I wish to put these rims on with as little an added thickness as possible so any ideas on where to get a reasonably priced safe/good set from?
3rd, Tires I want a wide performance style tire like the 24's are now and to stay in a lower profile but I want more rubber than 1/2 to 3/4 of an inch that the 24's have I would consider possibly a RWL as long as it is in the performance style I just don't want the truck tire look.
4th, this vehicle has the tmps sensors on it I want to find sensors that would work with these or what ever rims I replace them with but have read terrible reviews on the aftermarket ones I find online any suggestions? The last owner just chose not to put any sensors on it and the light is staying on now and just bothers me.

Can anyone help or offer suggestions thanks, Joe

Also found the Pacer 164p Mod that has a similar look but alas same 6x5.5 bolt pattern in a 16x10. 1 place said they have the 6x4.5 bolt pattern in a 16x8 can I still get that wide stance/performance look on an 8 inch rim that is not as deep? If so suggestions please on how to do that.


Attached Files Thumbnail(s)
   
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Wheels/Rims, Tires, adapters, & bolt patterns HELP! compguy1974 4 7,324 08-09-2015, 08:34 PM
Last Post: FRONT4X
  Tire pressure and aftermarket oversized/undersized tires Shift_Avenger 7 7,338 05-17-2009, 12:41 PM
Last Post: mdawg4x4
  Tires manufacturing date Shift_Avenger 1 3,825 04-14-2009, 08:17 PM
Last Post: Sandiegan05fronty
  TPMS and aftermarket wheels Shift_Avenger 3 4,304 04-09-2009, 12:15 AM
Last Post: carphreak
  highway tires carphreak 34 23,718 02-26-2009, 02:13 AM
Last Post: carphreak
  silverado/sierra/esky/yukon/etc... wheels fit? Thejudge 9 18,788 02-18-2009, 06:18 AM
Last Post: Thejudge
  cheap tires? Thejudge 6 6,925 02-03-2009, 09:59 AM
Last Post: Nitewulf
  What do you think of these wheels? Shift_Avenger 16 11,550 11-02-2008, 11:14 AM
Last Post: carphreak
  Tires for the Pathy, Not the Fronty mdawg4x4 9 7,183 10-01-2008, 08:17 PM
Last Post: mdawg4x4
  Aged Tires-Driving Hazard Sandiegan05fronty 6 5,279 07-24-2008, 08:55 PM
Last Post: Sandiegan05fronty

Forum Jump:


Users browsing this thread: 1 Guest(s)